TM 9-2330-297-14&P
Section X. WHEEL AND TIRE ASSEMBLY MAINTENANCE
Page
Page
Rims and Tires . .............................. .................
Spider, Brakedrum, and Wheel
Wheel Bearing .. ......................... .....................
Bearings .......................... ..................
RIMS AND TIRES
This task covers:
a. Removal (page 4-78)
b. Installation (page 4-79)
INITIAL SETUP
Tools
Tools - Continued
Handle, socket wrench, 3/4-inch
Torque wrench, 0 - 600 ft lb, 314-inch
square drive
square drive
Hydraulic jack
Two wheel chocks
Jack stand
Socket, 1 1/4- by 3/4-inch
Personnel Required
square drive
Two
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
1.
Wheel assembly
Wheel chocks (1)
Chock wheels on opposite side of assembly
being removed.
2.
Stud nuts (2)
Using 1 1/4-inch socket, loosen five
nuts (2). Do not remove.
3.
Axle beam
Hydraulic jack
a. Using jack (3), raise axle.
(3) and jack
b. Position jack stand (4) under axle
stand (4)
beam (5).
4.
Wheel assembly
Stud nuts (2)
Using 1 114-inch socket wrench, remove five
and rim clamps (6)
stud nuts (2) and rim clamps (6).
5.
Rim and tire
Spacer band (8)
Remove.
assemblies (7)
NOTE
For disassembly, repair, and reassembly of the tire, refer to TM 9-2610-200-14
Change 1 4-78
