TM 9-2330-297-14&P
SPIDER, BRAKEDRUM, AND WHEEL BEARINGS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY
8.
Wheel hub (1) and
Using 1 18-inch socket, 1 1/-inch
brakedrum (2)
wrench, and torque wrench, install five
capscrews (3), washers (4), and nuts (5).
Torque nuts (5) to 295 ft lb (400 Nm).
9.
Bearing cups
Using hammer and punch, install inner and
(6) and (7)
outer bearing cups (6) and (7) in wheel
hub (1).
10.
Inner bearing
a. Lubricate bearing (8) with GAA grease
cone (8) and
and place in hub (1). (See TM 9-214.)
grease seal (9)
b. Using hammer, install grease seal (9).
INSTALLATION
11.
Axle
Wheel hub (1) and
Using an assistant, place hub (1) and drum
brakedrum (2)
(2) on axle (10).
12.
Outer bearing
a. Lubricate bearing (11) with GAA grease
cone (11) and
and place in hub (1). (See TM 9-214.)
adjusting nut (12)
b. Install adjusting nut (12) and adjust
wheel bearings. See page 4-83.
13.
Wheel hub
Gasket (13), hub-
Place gasket (13) and hubcap (14) on wheel
cap (14), cap-
hub (1). Install five capscrews, washers
screws (15) and
and, using 112-inch socket, tighten
lockwashers (16)
screws (15).
NOTE
FOLLOW-ON MAINTENANCE Install rims and tires (page 4-79) and adjust brakes (page 4-59).
TASK ENDS HERE
TA223158
4-82
