TM 9-2330-297-14&P
WHEEL BEARING - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
4.
Wheel hub
Wheel bearings
a. Using 3 7/8-lnch socket, loosen adjusting nut (1)
b. Turn wheel assembly (2) Tighten adjusting nut
(1) with 3 7/8-inch socket and torque wrench,
against bearing shoulder on spindle. Torque
adjusting nut to 250-300 ft lb (339-407 Nm).
This torque will automatically adjust
new bearings to a range of 0.005
tight to 0.007 loose.
c. Install lockwasher (3) on axle.
d. Slide lockwasher (3) against adjusting nut (1)
If dowel pin (4) does not enter hole
in lockwasher (3), do step e.
e. Remove lockwasher (3) Turn it over and
reinstall. If dowel pin (4) does not enter hole
in lockwasher (3), repeat steps a thru e.
f. Using 3 5/16-inch socket and torque wrench,
install locknut (5) and torque to 250-300 ft lb
(339-407 Nm)
5.
Gasket (6), hubcap
a
Place gasket (6) and hubcap (7) on
(7), lockwashers (8)
wheel hub (10) and Install five lock-
and capscrews (9) washers (8) and capscrews
(9)
b. Using 1/2-inch socket, tighten cap-screws (9)
6.
Axle
Hydraulic jack (11)
Lower and remove jack (11).
TASK ENDS HERE
TA223160
Change 1 4-84
