TM 9-2330-356-14
(3) Pull axle from shoe to be removed. Remove
shoe.
WARNING
Installation of Landing Gear Shoe.
b.
Dry cleaning solvent P-D-680 is toxic and
(1) Position shoe at end of landing gear leg
flammable. Always wear protective goggles
assembly. Insert axle through one side of shoe, through
and gloves, and use only in a well-ventilated
inner washer, leg, other inner washer, and through other
area. Avoid contact with skin, eyes, and
side of shoe.
clothes, and DO NOT breathe vapors. DO
NOT use near open flame or excessive heat.
(2) Reinsert outer washers and roll pins.
The solvent's flash point is 100F-138F
(38C-59C). if you become dizzy while us-
(3) Remove jacks and blocking.
ing cleaning solvent, immediately get fresh
air and medical help. If solvent contacts eyes,
Removal of Landing Gear Leg Assembly.
c.
immediately wash your eyes with water and
get medical aid.
(1) Remove shoe of leg to be removed (para a).
a.
Service. Clean with water and stiff brush. Use dry
nuts which attach braces (fig. 4-93) to the leg assembly.
Remove capscrew, lockwasher, and nut attaching rod
Replacement. If bracket needs replacing, notify
b.
coupling to leg. If rod and brace cannot be moved out of
way, loosen nuts on ends of brace attached to semitrailer
direct support maintenance.
frame.
c.
Repair. Repair is limited to straightening bracket.
(3) If leg with gear box is to be removed, remove
capserew, washer, and nut that attaches coupling to leg.
Remove four mounting capscrews, washers, and nuts, and
remove gearbox assembly and coupling,
(4) Remove eight capscrews, washers, and nuts
securing leg to semitrailer frame. Remove leg.
Installation of Landing Gear Leg Assembly.
d.
(1) Position leg assembly onto semitrailer frame.
Attach with eight capscrews, washers, and nuts.
(2) Position gearbox assembly and coupling on
landing gear leg. Install two mounting capscrews, washers
and nuts.
(3) Fasten coupling to operating shaft with
capscrew, washer, and nut.
(4) Attach brace to leg assembly with capscrew,
lockwasher, and nut.
NOTE
Ensure that legs are extended equally before
Removal of Landing Gear Shoe.
a.
holes are alined and screw inserted in rod
coupling.
(1) Block wheels to prevent semitrailer move-
ment. Lift front end of semitrailer with jacks, and block se-
(5) Attach rod coupling to leg assembly with a
curely.
capscrew, lockwasher, and nut.
(2) Remove roll pins and outer washer from
(6) Install shoe on leg assembly (para b).
lower ends of leg assembly and axle.