Section XV. MAINTENANCE OF TANK BODY PARTS

TM 9-2330-356-14

4-55. Board Assembly, Landing Gear (Fig. 4-94)

Replace board assembly by removing two screws,

washers, nuts, handle, and removing chain from handle.

Attach chain to handle and secure handle to board

assembly with two screws, washers, and nuts.

Replace chain assembly by removing chain from

bracket and board handle. Attach chain to bracket and

handle.

Figure 4-94. Ground Board Assembly,

Section XV. MAINTENANCE OF TANK BODY PARTS

Installation.

Brackets, Splash Plates, and Mudflaps

4-56.

(Figs. 4-95 and 4-96)

(1) Position front splash plate and fasten to

frame with three bolts and nuts.

Removal.

(2) New mudflaps are stocked in one size only.

Cut and drill the mudflaps using the dimensions shown in

(1) Remove three bolts and nuts holding front

figure 4-98.

splash plate to frame.

(3) Put mudflaps in position, place bracket on top

(2) Remove four bolts, washers, and nuts from

side of mudflaps, and fasten to rear bumper with four

capscrews, washers, and nuts.

bracket holding mudflaps to rear bumper.