(b) Loosen hose clamp (1) and slide off hose
and hood as a unit.
(c) Loosen hose clamps (2) and (4), and
remove hose (3) and pipe (5).
(d) Loosen clamp (8) and remove plug (9).
(a) Reverse instructions in step (1).
Replacement of Piping.
(a) Remove coupling (10) from coupling
(b) Remove two nuts and bolts from coupler
(12) and remove coupler.
(c) Provide support for pipe assembly (16) so
it will not fall.
(d) Remove four nuts (13), four washers
(14), and two U-bolts (15). Remove pipe assembly (16).
Replacement of Electrical Clip. Remove screw and
(e) Remove coupling (11) from pipe.
nut that attaches clip to cable, then remove clip. Remove
screw and nut from new clip and replace securing cable
(f) Remove eight capscrews (17) and nuts
between head of screw and clip.
4-97. Vehicle Nozzle (M969 and M969A1)
(g) Remove vent (19) and gasket (20).
(2) Installation. Install pipe in reverse order of
removal steps (a) through (g). When installing coupling
(1) Pull hose reel hose out far enough to work on
Replacement of Ground Receptacle.
(2) Unscrew nozzle from end of hose.
(3) If reducer is removed with nozzle, unscrew
bushing and screw back into hose.
(a) Remove ground wire from tool box by
Installation. Screw nozzle into reducer bushing on
removing screw and nut.
end of hose. Tighten securely. Rewind hose reel hose
nuts (22) and remove receptacle (23).
(c) If bracket (24) is to be removed, remove
Replacement of Vapor Recovery Hood and Hose.
two capscrews (25) and nuts (26), and remove bracket (24).
(2) Installation. Install ground receptacle by
(a) Loosen clamp (6) and remove hood (7).
reversing steps (a) through (c).