TM 9-2330-357-14&P
5-11. OUTRIGGER ACTUATOR ASSEMBLY REPAIR (Con't).
40.
Remove and discard lockwire (50).
41.
Remove seal screw (48).
42.
Hold seal (49) stationary and turn ball nut (29)
clockwise to expose seal. Remove seal from
ball nut and discard seal.
b. CLEANING AND INSPECTION
1.
Remove all buildup of grease or dirt by wiping a with clean rag.
2.
Remove old gasket material and sealing compound from mounting surfaces.
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear
protective goggles and gloves, and use only in a well-ventilated area.
Avoid contact with skin, eyes, and clothes, and DO NOT breathe vapors.
DO NOT use near open flame or excessive heat. The solvent's flash point
Is 100 -138 (38 -59 ). If you become dizzy while using cleaning
F
F
C
C
solvent, immediately get fresh air and medical help. If solvent contacts
eyes, immediately wash your eyes and get medical aid.
3.
Immerse mounting surface parts in dry cleaning so lvent until all remaining sealing compound is softened
and remove with a medium bristle brush.
WARNING
Dry cleaning solvent, P-D-680, Is toxic and flammable. Always wear
protective goggles and gloves, and use only in a well-ventilated area.
Avoid contact with skin, eyes, and clothes, and DO NOT breathe vapors.
DO NOT use near open flame or excessive heat. The solvent's flash point
Is 100 -138 (38 -59 ). If you become dizzy while using cleaning
F
F
C
C
solvent, Immediately get fresh air and medical help. If solvent contacts
eyes, immediately wash your eyes and get medical aid.
4.
Clean remaining parts with a clean rag or medium bristle brush and dry cleaning solvent and allow to dry.
5.
Inspect for damaged or missing hardware.
6.
Inspect bearings for unusual wear or abrasion.
5-37