TM9-2330-358-14&P
NOTE
Tag wires to aid in installation. If wire connectors
are to be repaired or replaced, go to wire connector
procedure (para. 4-26).
Removal is not necessary for lamp, lens, or door
assembly replacement. If circuit marker bands are
Removal.
a.
WARNING
Disconnect all outside power before performing any
maintenance on the electrical system. Failure to do so
could result in injury.
CAUTION
Do not pull on wires, only pull connectors apart.
Pulling on wires could damage them.
(1) Pull connectors (1, fig. 4-8) apart.
(2) Remove two screws (2) and lockwashers (3) that hold composite light
assembly (4) to frame (5).
(3) Remove composite light assembly (4).
Composite Light
Figure 4-8.
4-30
