TM9-2330-358-14&P
CAUTION
Make sure electrical wires are pulled down when
installing nose box cover. Failure to do so will cause
damage to the electrical system.
NOTE
Item 2 is on the M871 semitrailer only.
(4) Pull wires down from center hole in kingpin plate while installing nose box
cover (3) on nose box (4). Install ten washers (2) and screws (1) to
secure cover (3) to semitrailer.
(5) Connect electrical power and test for proper operation.
TASK ENDS HERE
4-19.
RESISTORS
This task covers:
Removal
Installation
INITIAL SETUP
Tools
General mechanics tool kit
Equipment Condition
Nose box cover removed
a.
Removal.
WARNING
Disconnect all outside power before performing any
maintenance on the electrical system. Failure to do so
could result in injury.
(1) Remove two screws (1, fig. 4-5), washers (2) and nuts (3).
NOTE
Item 2 is on the M871 semitrailer only.
(2) Remove resistor (4).
4-25
