TM9-2330-368-14 & P
Section II. SERVICE UPON RECEIPT OF MATERIAL
Page
Unpacking and Checking the Equipment . . . . .4-2
4-4. UNPACKING AND CHECKING THE
4-5. SERVICING THE EQUIPMENT
EQUIPMENT
a. Perform the preventive maintenance checks
a.
Remove any metal strapping, plywood,
and services contained in Tables 2-1 and
tapes, seals, wrapping paper or any other
4-1.
shipping and protective items.
b. Lubricate all points as shown in the Lubri-
WARNING
cation Instructions (Chapter 3, Section I)
Dry cleaning solvent (P-D-680) used
regardless of interval.
to clean parts is potentially dangerous
c. Schedule the next preventive maintenance
to personnel and property. Do not use
checks and services on DD Form 314, Pre-
near open flame or excessive heat.
ventive Maintenance Schedule and Record.
Flash point of dry cleaning solvent
is 138F (59C).
d. Report all deficiencies on DA Form 2407
if the deficiencies appear to involve un-
If any exterior parts are coated with rust
b.
satisfactory design.
preventive compound, remove it with
cleaning solvent (P-D-680).
e. Perform a break-in road test of 25 miles at
c.
Inspect the equipment for damage incurred
a maximum speed of 50 miles per hour.
during shipment.
d. Check the equipment against the packing
slip to see if the shipment is complete.
Report all discrepancies in accordance
with the instructions of DA Pam 738-750.
Change 1
4-2
