TM9-2330-368-14 & P
Section V. MAINTENANCE OF ELECTRICAL SYSTEM
Page
Page
Testing Electrical System . . . . . . . . . . . . . 4-17
Composite Lights . . . . . . . . . . . . . . . . . . . ...4-16
Wiring Harness . . . . . . . . . . . . . . . . . . . . . ...4-18
Clearance Marker Lights . . . . . . . . . . . . . . ...4-17
4-10. COMPOSITE LIGHTS
Materials/Tools
General mechanics tool kit
a. Removal.
(1) Tag and disconnect connectors (1)
from wiring harness. Remove plastic
tyrap (2).
(2) Remove two cap screws (3) and lock
washers (4) to detach each composite
light (5). Remove light (5).
b. Repair.
(1) Loosen six captive screws (6) and re-
move lens (7).
NOTE
Do not remove packing (8) un-
less damaged.
(2) Replace any defective lamps
(9, 10 and 11).
(3) Install new packing (8) if packing was
removed in lens (6) and fasten unit to
body (12) with captive screws (6).
c. Installation.
(1) Install composite light (5) on trailer
with two cap screws (3) and lock
washers (4).
(2) Connect connectors (1) to wiring har-
ness. Make sure that tag or marker
numbers on wires correspond. Install
tyrap (2).
4-16
