TM9-2330-368-14 & P
lock nuts (8). Be sure ground lead (11)
4-13. WIRING HARNESS (cont)
and lock washer (10) are under one of
the lock nuts.
(2) Run wiring harness (4) along frame and
through grommets (14 and 15) as
(4) Install tyraps (3) around composite
shown. Run harness over cross beams
light wires and mounting bracket.
and inside of main beam. Install clamps
(7) over harness and attach to studs (6)
(5) Connect connectors (1 and 2) to all
with nuts (5) in 19 places. Run rear of
lights.
harness through grommet (14) to left
side.
(6) Connect HEMAT to towing vehicle and
check operation of all lights.
(3) Position connector (12) and cover (13)
on frame. Connector must have A con-
tact upward. Install cap screws (9) and
4-20
