TM 9-2330-371-14&P
HUB AND DRUM - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
INSTALLATION CONTINUED
Put on with bolts (3) through holes in
Hub (2) and
Adapter plate (1)
22.
hub (2).
bolts (3)
Bolts (3)
Drive in using hammer until hub (2) and
Hub (2) and
23.
adapter plate (1) are seated to each
adapter plate (1)
other.
With help of assistant, slide into place.
Hub (2) and drum
Spindle (4)
24.
(5) assembly
Bearing (6)
a. Lubricate (page 4-5).
25.
b. Put on.
Adjusting nut (7)
a. Put on and tighten using hub-nut
26.
wrench until hub (2) binds on spindle
(4) when rotated.
b. Back off one-eighth turn using hub-nut
wrench.
NOTE
Check adjustment by grasping drum and attempting to
rock it on spindle. If bearings are properly adjusted,
movement of brakedrum will scarcely be felt or seen,
with drum turning freely.
Key Iockwasher (8)
a. Slide on.
27.
b. Turn adjusting nut (7) clockwise
using hub-nut wrench until pin (9)
drops into nearest hole.
Put on and tighten using hub-nut wrench.
Jamnut (10)
28.
Put in place and line up holes.
Hubcap (11) and
Hub (2)
29.
gasket (12)
Put in and tighten using 1/2-inch socket
Six screws (13) and
Hub (2) and
30.
and handle.
hubcap(n)
4-116
