TM 9-2330-373-14 & P
4-15.
COMPOSITE STOPLIGHT TAILLIGHT (cont)
REMOVAL
1.
Tag and disconnect four connectors (6) from harness connectors and ground wire (8) from chassis.
2.
Reach behind dolly frame and remove two screws (5) and lock washers (4) securing light assembly to mounting
channel in dolly crossmember. Remove light.
LAMP REPLACEMENT
1.
Loosen six retaining screws (1)
on lens
assembly (2).
2.
Remove lens assembly (2) with attached
preformed packing (3).
3.
Push in on lamp (4, 5, or 6) and turn
counterclockwise to remove.
4.
Insert lamp (4, 5, or 6) in socket socket, push in
and turn clockwise.
1.
Screw
5.
Lamp
2.
Lens assembly
6.
Lamp
3.
Packing
7.
Body
4.
Lamp
8.
Ground wire
5.
Test lamps as follows: Turn service switch on
towing vehicle to ON position to test service tail
lamp (5).
6.
Operate brake pedal on towing vehicle to test
stoplight lamp (4).
7.
Operate turn signal lever in towing vehicle to test
operation of turn signal lamp (4).
8.
Test blackout lamp (6) by placing towing vehicle
switch in BLACKOUT mode of operation and
then operating the proper switch, brake pedal, or
turn signal lever
TA 314769
4-48
