TM 9-2330-373-14 & P
4-15.
COMPOSITE STOPLIGHT TAILLIGHT (cont) 1
CLEANING
CAUTION
Do not use cleaning solvent. It will damage the body of the light.
1.
Clean exterior of light, using clean water and soap solution.
2.
Clean interior of body and lens assembly, using clean water and soap solution. Dry thoroughly.
INSPECTION
1.
Inspect preformed packing and replace if damaged.
2.
Inspect lens assembly for cracks, warpage, or broken lens. Replace lens assembly if defective.
3.
Inspect wiring and sockets.
Replace light assembly if defective.
ASSEMBLY
1.
Position preformed packing (3)
and
lens
assembly (2) on body (7).
2.
Secure with six captive screws (1).
1.
Screw
3. Packing
2.
Lens assembly
7. Body
INSTALLATION
1.
Position light assembly on mounting channel and
secure with two screws (5) and lock washers (4).
2.
Connect four connectors (6) to harness
connectors and connect ground wire (7) to chassis.
3.
Test operation of light. Operate turn signal lever
in towing vehicle to test operation of turn signal lamp.
4.
Test blackout lamp by placing tow-
4.
Lock washer
ing vehicle switch in BLACKOUT mode
5.
Screw
and then operating the proper switch,
6.
Connector
brake pedal and turn signal lever.
7.
Ground wire
TA 314770
4-49
