TM 9-2330-373-14 & P
4-23.
HYDRAULIC MASTER CYLINDER (cont)
REMOVAL (cont)
1.
Master cylinder
5.
Brake air chamber
2.
Hose
6.
Stud
3.
Nut
7.
Bracket
4.
Washer
8.
Push rod
3. Disconnect flexible hose (2) from rear of master cylinder (1).
4. Remove three nuts (3) and lock washers (4) which attach master cylinder to bracket (7) and brake air chamber
(5).
5. Move master cylinder to one side enough to detach rubber bellows. Remove master cylinder.
INSTALLATION
1. Position master cylinder (1) over the three studs (6) and against bracket (7). Make sure that brake air chamber
push rod (8) is properly seated in master cylinder piston.
2. Install rubber bellows over lip on master cylinder.
3. Secure cylinder (1) in place-with three nuts (3) and lock washers (4).
4. Connect flexible hose (2) to rear of master cylinder.
5. Close drain cock on air reservoir.
6. Fill master cylinder and bleed system.
TA 314785
4-65
