TM 9-2330-373-14 & P
4-22.
BRAKE BACKING PLATE AND SUPPORT AND ADJUSTER ASSEMBLY (cont)
INSTALLATION (cont)
NOTE
The cap screws are installed in mounting holes at the extreme ends
of support and adjuster assembly.
8. Install two cap screws (from rear of axle flange) through two center mounting holes of upper support and adjuster
assembly. Secure cap screws with two lock washers and nuts.
4-23.
HYDRAULIC MASTER CYLINDER
THIS TASK COVERS
a.
Servicing
Troubleshooting Reference
b.
Removal
Item No.
c.
Installation
6. No brakes or weak brakes
7. Slow brake application or
slow release
8. Grabbing brakes.
Test Equipment Required:
None
Personnel Required:
1
SERVICING
NOTE
Master cylinder service includes only flushing and refilling
hydraulic system (refer to hydraulic system schematic, page 4-75
for location of master cylinders).
4-63