TM 9-2330-373-14 & P
4-22.
BRAKE BACKING PLATE AND SUPPORT AND ADJUSTER ASSEMBLY (cont)
INSTALLATION
1. Slide one washer (8) on threaded end of spring
and bolt assembly (10) and install, threaded end
first, through opening at rear of brake backing
plate (9).
2. Install second washer (8) and adjusting gear (7)
on threaded end of stud.
3. Secure gear to stud with lock washer (6) and nut
(5).
4. Following scribed marks made at removal,
position backing plate (9) against flange of axle
and secure with eight cap screws, lock washers
and nuts.
5. If removed, install the anchor pin in large
opening at end of support and adjuster assembly
(1).
6. Before installing the support and adjuster
assembly, make certain adjusting screw (4) is
properly positioned in support (2) to receive the
brake shoe which seats on its top surface. The
adjusting screw should be recessed one inch
below the rim of the support. Rotation of
adjusting wheel (3) will adjust screw to required
dimension.
7. Following the scribed marks made at removal,
position each support (2) on front of brake
backing plate (9). Make certain adjusting wheel
meshes with installed adjusting gear. Secure
each support and adjuster assembly to backing
plate with two cap screws (12) and lock washers
(11).
1.
Support and adjuster
2.
Support
3.
Adjusting wheel
4.
Adjusting screw
TA 314783
4-62