TM 9-2330-373-14 & P
4-22.
BRAKE BACKING PLATE AND SUPPORT AND ADJUSTER ASSEMBLY (cont)
REMOVAL
1.
2.
1. Support and adjuster assembly
11. Washer
9. Backing plate
12. Screw
3.
Scribe alinement marks on support and adjuster assembly, brake backing plate, and axle flange to insure proper
installation.
4.
Remove two nuts, two lock washers, and two cap screws at rear of axle flange. This hardware partially secures
upper anchor support and adjuster assembly (1) to brake backing plate (9), and brake backing plate to axle flange.
5.
Remove two cap screws (12) and lock washers (11) securing each support and adjuster assembly (1) to brake
backing plate (9).
NOTE
Care should be taken to avoid loss of anchor pins which will drop out of support
and adjuster assembly (1) as they are removed.
6.
Carefully lift support and adjuster assembly (1) from backing plate (9) and out of mesh with adjusting gear.
TA 314781
4-60