TM 9-2330-376-14&P
4 - 2 4 . INTERVEHICULAR CABLE ASSEMBLY REPAIR (Con't).
6.
Install spring (6) on cable (7).
7.
Slide bushing (5) and shell (3) onto cable (7).
8.
Solder eight new contacts (2) to cable (7). Push contacts into rear of insert (1). Remove tags.
9.
Slide shell (3) over insert (1).
10.
Tighten clamp (4) on shell (3).
b.
LUG TERMINAL REPLACEMENT
1.
Cut off lug terminal (9) from ground lead (8). Discard lug terminal.
2.
Strip ground lead (8) to approximate depth of new lug terminal (9).
3.
Crimp new lug terminal (9) onto ground lead (8).
c. TERMINAL ASSEMBLY REPLACEMENT
1.
Slide shell (10) and insulator (11) off terminal assembly (12).
2.
Cut off terminal assembly (12) and discard.
3.
Slide insulator (11) and shell (10) off wire (14).
4.
Strip wire (14) approximately 1/8 in. (3 mm).
5.
Slide shell (10) and insulator (11) over wire (14).
6.
Place wire (14) in cylinder end of new terminal assembly (12) and crimp.
7.
Slide insulator (11) and shell (10) over terminal assembly (12).
d.
MARKER BAND REPLACEMENT
1.
Open tabs and remove marker band (13) from wire (14). Discard marker band.
2.
Etch circuit number on new marker band (13). Refer to wiring diagram (para 4-27).
3.
Place new marker band (13) over wire (14) and bend tabs closed.
FOLLOW-ON TASKS:
Install intervehicular cable assembly (para 4-23).
4-23
