TM 9-2330-381-14
4-63.
SPARE WHEEL CARRIER (CONT)
INSTALLATION
1.
Attach winch cable (5) to spare wheel carrier (14) by wrapping cable under wheel supports and attaching hook
over cable to form loop.
2.
Operate davit winch (11) to lift spare wheel carrier (14) to clear gooseneck.
3.
Swing davit arm (10) and winch cable with spare wheel carrier (14) into position on gooseneck.
4.
Install four bolts (4), eight washers (3), and four slotted nuts (2). Torque slotted nuts (2) to 420 lb-ft (570 Nm).
Then, tighten further to aline next available slot with cotter pin hole. If necessary, install additional washers (3)
under slotted nuts (2) to properly aline slotted nuts and cotter pin holes for full engagement of cotter pins (1) when
slotted Nuts are properly torqued. Install four cotter pins (1) to secure nuts.
5.
Remove winch cable (5) from spare wheel carrier (14).
6.
Return pulley clamp (9) back to stow position at end of davit arm (10), install hitch pin (8), and secure with linch
pin (7).
7.
Return davit arm (10) to stow position, install hitch pin (13) through davit base (6), and secure with linch pin (12).
8.
Attach winch cable (5) hook on davit base (6) and take up slack in cable.
FOLLOW-ON MAINTENANCE
1.
Install steering hydraulic cylinders (para. 4-55).
2.
Install spare tires (para. 3-6).
4-64.
FRONT SUPPORT LEGS
This task covers: a. Disassembly b. Inspection c. Assembly
INITIAL SETUP
Tools
General mechanics tool kit, item 16, appx. B
Degreaser tank, 20 gl, item 17, appx. B
Gloves, chemical and oil protective, item 17, appx. B
Goggles, industrial, item 17, appx. B
Socket set, 3/4" dr, item 18, appx. B
Socket set, 3/4" dr impact, item 18, appx. B
4-310 Change 1
