TM 9-2330-381-14
5-23.
GOOSENECK CYLINDER (CONT)
22.
Lower lifting device (4) until gooseneck cylinder (3) is supported on transmission jack (28).
23.
Secure gooseneck cylinder (3) to transmission jack (28).
24.
Loosen and remove lifting strap (2) from hook of lifting device (4). Leave lifting strap (2) on gooseneck cylinder
(3).
INSTALLATION
WARNING
Lifting strap must be placed around gooseneck cylinder in noose to prevent injury
to personnel.
1.
If not already installed, wrap lifting strap (2) around gooseneck cylinder (3) through loop to form slip-hook (noose).
If necessary, secure gooseneck cylinder (3) onto transmission jack (28).
2.
Maneuver transmission jack (28) near platform lug weldment.
3.
Raise cylinder (3) into position and push transmission jack (28) out of the way.
4.
Raise and install gooseneck cylinder (3) into lug weldment. Make sure cylinder bearings are approximately
straight and ready for lower cylinder pin installation.
5.
Apply antiseize compound to lower cylinder pin (21) and bushing (25). Install V-ring seal (26) onto lower cylinder
pin (21) and V-ring seal (27) onto bushing (25).
6.
Hand install lower cylinder pin (21) through platform lug weldment until pin is partially started into bearing on
gooseneck cylinder (3).
CAUTION
When driving lower cylinder pin through cylinder and platform lug weldment, use
caution so that the pin is driven in straight or cylinder bearing may turn the pin and
cause damage to lower cylinder pin or V-ring seal.
7.
Tap lower cylinder pin (21) with hammer or heavy object until pin (21) is through platform lug weldment and lower
bearing on gooseneck cylinder (3).
5-112 Change 1
