TM 9-2330-381-14
CAUTION
Bolt must be fully engaged (bottomed out) in pin prior to striking with hammer or
damage to equipment will result.
19.
Install a 2-inch (5.1 cm) hardened bolt into hole in bushing (25). Strike bolt with hammer. When bolt can no
longer be struck, remove bolt and install a 4-inch (10.2 cm) hardened bolt. Drive out lower cylinder pin (21).
Remove and discard V-ring seal (26).
WARNING
All personnel in area of gooseneck cylinder must stand clear of cylinder and lifting
device while lifting device is repositioned or injury to personnel may result.
20.
Drive bushing (25) out of gooseneck cylinder (3) and platform lug weldment. Remove V-ring seal (27) from
bushing (25). Discard V-ring seal.
CAUTION
Top of gooseneck cylinder may start to move outward, away from platform, as
lifting device is repositioned/centered over transmission jack. Lifting device
operator must pay out slack to lifting strap as the lifting device is moved to prevent
excess strain on lifting straps or damage to equipment may result.
21.
While maintaining tension on lifting strap (2), reposition lifting device (4) over top of transmission jack (28).
5-111