TM 9-2330-381-14
5-23.
GOOSENECK CYLINDER (CONT)
14.
Use crowbar to pry downward on gooseneck cylinder (3) while lowering lifting device (4) and allow cylinder to start
to compress. Check that fluid is draining into drain pan.
15.
Continue to lower lifting device (4) and pry downward on cylinder until upper bearing casting on gooseneck
cylinder (3) is lower than cylinder mount on gooseneck lug (1).
16.
Make sure gooseneck cylinder (3) is secured by keeping tension on lifting device (4).
17.
Disconnect three hydraulic lines (7) from gooseneck cylinder (3). Install caps/plugs into lines and gooseneck
cylinder (3).
18.
Remove screw (18), lockwasher (19), and washer (20) from lower cylinder pin (21). Remove lubrication fitting
(22), bolt (23), and lockwasher (24) if present. Discard bolt and lockwashers.
5-110 Change 3
