TM 9-2330-383-14&P
Section II. SERVICE UPON RECEIPT OF MATERIAL
4-4. UNPACKING AND CHECKING THE EQUIPMENT
a. Remove any metal strapping, plywood, tapes, seals, wrapping paper or any
other shipping and protective items.
________
WARNING
Dry cleaning solvent (MIL-PRF-680, type I) is extremely flammable,
toxic, and is an irritant to the eyes, skin, and respiratory system. Do
not use near open flame or excessive heat. Do not breathe the vapors.
point of dry cleaning solvent is 140F.
b. If any exterior parts are coated with rust preventive compound, remove it
with dry cleaning solvent (MIL-PRF-680, type I) (item 6, appendix E).
c. Inspect the equipment for damage incurred during shipment. If the equipment
has been damaged, report the damage on DD Form 6, Packaging Improvement
Report.
d. Check the equipment against the packing slip to see if the shipment is
complete. Report all discrepancies in accordance with the instructions of DA
PAM 738-750.
4-5. SERVICING THE EQUIPMENT
b. Lubricate all points as shown in the Lubrication Instructions (chapter 3,
section I), regardless of interval.
c. Schedule the next PMCS on DD Form 314, Preventive Maintenance Schedule and
Record.
d. Report all deficiencies on DA Form 2407 if the deficiencies appear to involve
unsatisfactory design.
e. Perform a break-in road test of 25 miles at a maximum speed of 55 miles per
hour.
Change 1