TM 9-2330-383-14&P
4-7. UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) (CONT)
(5)
Air Hoses. Look for wear, damage and leaks and make sure clamps and
fittings are tight. If a leak comes from a loose fitting or connector, tighten it.
If something is broken or worn out, either correct it or report it to support
maintenance. Refer to appendix B.
S - Semiannually
A - Annually
Item
Interval
ITEM TO BE INSPECTED
No.
S
A
Procedure:
NOTE
Perform operator PMCS prior to or in conjunction with unit PMCS
if:
There is a delay between the daily operation of the
equipment and the unit PMCS.
Regular operator is not assisting/participating.
1
WHEELS AND TIRES
a.
Rotate and match tires according to design and degree of
wear. See TM 9-2610-200-24 for acceptable limits in
matching tires. Tighten wheel nuts to 450-500 lb ft. (See
sequence in para. 3-5.)
b.
Check steering alinement in accordance with para. 4-29 of
this manual.
2
SERVICE BRAKES
a.
Inspect hub and drum for visible wear and scoring (para.
b.
Inspect wheel bearings for visible wear and seal for
deterioration and damage (para. 4-26).
c.
Inspect brake shoes for wear (para. 4-16).
d.
Inspect camshafts for visible wear and damage (para.
e.
Inspect camshaft bearings for visible wear (para. 4-17).
