TM 9-2330-398-10
2-20.
NONFILTERED FUEL SERVICING INVOLVING USE OF ENGINE AND PUMP
(continued).
6.
Remove dust cover (5) from outlet B (6) and
connect 4-inch (10.16-cm) bulk fuel hose to
outlet B (6) and storage facility.
7.
Put valve E (2) in UNLOAD position.
8.
Pull emergency valve A control handle (1) to
OPEN position, and open valves B, F, and H (7,
10, and 11).
9.
Adjust engine speed for desired flow rate (refer
to Table 2-3).
10.
Idle down engine at end of operation. Close all
valves, and disconnect 4-inch (10.16-cm) bulk
fuel hose. Drain hose into suitable container,
and install dust cover (5) on outlet B (6).
11.
Put bulk fuel hoses in hose trough and secure
latches.
12.
Stop engine (para 2-17c).
13.
Drain accumulated water (para 2-19d).
14.
Remove static reel grounding cable (4) from storage facility.
15.
Store and cover fire extinguishers.
C.
NONFILTERED DISPENSING
NOTE
Use this procedure for fuel that does not require filtering and is routed directly from pump to hose
reels, bypassing filter/separator.
1.
Review general fuel-handling instructions (para 2-16).
NOTE
Operation begins and ends with all valves closed.
2.
Make sure all valves are closed.
NOTE
If two semi-trailers are being serviced, make sure they are both grounded to each other using
separate static reel grounding cables.
3.
Unreel static reel grounding cable (4), and connect it to a suitable ground.
2-54
