TM 9-2330-398-10
2-20.
NONFILTERED FUEL SERVICING INVOLVING USE OF ENGINE AND PUMP
(continued).
4.
Remove fire extinguishers and bring them to the point of operation.
5.
Start engine (para 2-17b). When engine is warm, adjust engine speed to 1000-1200 rpm.
6.
Put valve E (2) in UNLOAD position.
7.
Pull emergency valve A control handle (1) to OPEN position, and open valves F, H, and K (10, 11, and 9).
8.
Reset meter (12 or 14) to zero by pushing reset knob (13) and turning clockwise.
NOTE
Valves P and R may be opened at the same time if two vehicles are being serviced. Make sure
both vehicles are grounded to each other and to earth ground.
9.
Open valve P (19) if front hose (21) reel is being used, or open valve R (15) if rear hose (18) reel is being used.
10.
Adjust engine throttle for desired flow rate (refer to Table 2-3).
11.
Release lock (16) on hose (18 or 21) reel and unwind hose.
12.
Insert fuel-dispensing nozzle (17 or 20) into vehicle fuel tank/container. Squeeze fuel-dispensing nozzle (17 or 20)
trigger to start flow.
13.
At end of operation, release trigger of fuel-dispensing nozzle (17 or 20) and remove nozzle from vehicle fuel
tank/container.
14.
Adjust engine speed to 1000-1200 rpm.
15.
Rewind hose (18 or 21) and tighten lock(s) (16) on hose (18 or 21) reel.
2-55
