TM 9-2350-222-10-2
OPERATE MOLDBOARD (PERFORM MOLDBOARD OPERATIONS) - Continued
To Lower Moldboard:
Make Sure:
You have read WARNING and CAUTION (page 2-256).
Hydraulic system has been started (page 2-249).
Moldboard is prepared for operations (page 2-253).
CAUTION
After the moldboard has been set to the proper depth,
ensure that the control handle returns to HOLD position
and shut OFF Hydraulic pump switch to avoid damage
to system while in use. For further adjustments to
moldboard turn ON and OFF Hydraulic pump as
needed.
NOTE
When you hold BULLDOZER CONTROL VALVE
LEVER (B) in LOWER position, moldboard will
continue to lower until it reaches its lowest
point This may raise front of vehicle.
1. Move and hold BULLDOZER CONTROL VALVE lever (B) down
to LOWER position. Release BULLDOZER CONTROL VALVE
TA132397
lever (B) when moldboard is at desired height. BULLDOZER
CONTROL VALVE lever (B) will return to HOLD position.
Change 5
2-257
