TM 9-2350-222-10-3
MAINTAIN TRACK (ADJUST TRACK TENSION -
MECHANICAL) - Continued
NOTE
To adjust track tension on right side of vehicle, pull wrench (K) up to increase
tension and push down to decrease tension. On left side of track use
opposite directions.
CAUTION
If tightening tension, do not move ad-
justing link (M) beyond groove (P). If
track tension is still too loose after
groove appears, remove track link
(stow removed track link in fender
stowage box). If a track link must be
removed when adjusting one side, the
other side does not have to be short-
ened.
18. Loosen or tighten track tension as required by turning adjusting
link (M) with wrench (K).
19. Repeat step 9. (Read CAUTION on top of this page.)
NOTE
When installing and tightening Iockwasher (N) and locking screw (L), make
sure high side (Q) of adjusting link is lined up with locking screw (L).
20. Install and tighten lockwasher (N) and locking screw (L).
21. Lubricate adjusting link (LO 9-2350-222-12).
TA249239
22. Return tools and supplies to stowage.
3-89
Change 2
