TM 9-2350-222-10-3
MAINTAIN TRACK (INSTALL THROWN TRACK)
NOTE
Four crewmembers are needed to do this
procedure.
Tools and Supplies:
q Get crowbar (A) from left front
fender box.
q 30 foot length of 3/4 inch rope (B)
(item 57, Appendix D).
q 3 foot by 3 foot metal plate or 3
foot by 3 foot by 3 inch thick wood
board (C),
q 2, 1 foot by 3 inch by 2 foot pieces
of wood (D) (to block track).
Make Sure:
q Hydraulic system
is turned off
(page 2-252).
Engine
is
off.
q
CAUTION
I f vehicle cannot be moved under its own
power without causing damage to vehicle or
track, do not try to remove track. Get help
from organizational maintenance.
1. Remove rear fender (page 3-96).
2. Break track (if not already broken) (page 3-71).
CAUTION
Make sure personnel are clear from rear of ve-
hicle. Use ground guide to direct movement
of track.
3. Start engine, warm up, and let idle (page 2-205).
4. Drive vehicle rearward slowly until track (E) is free of drive
sprocket (F) (page 2-233).
TA132920
3-90.4
Change 2
