shaft.
Note. When installing thrust plate, counterbore
(6)
Slide adjustment collar onto shaft.
of plate must face rings, so that the plate fits over
(7)
Install the three dogs to pins on clutch
the rings.
body.
(4) Stack disks in the order indicated in
(8) Slide shifter sleeve onto clutch body,
install on shaft, and secure to shaft with anchor pin.
over the keys, and slide onto shaft.
f.
Adjustment. To adjust clutch assembly,
(5) Install adjustment lock spring into the
refer to figure E-16.
two notches on pressure plate, and slide plate onto
Section VII. REPAIR PART LIST AND SPECIAL TOOLS
organizational level for the early model M8A3 bulldozer.
E-42. General
For listing of common repair parts, special tools, test
E-43. This section provides a list of peculiar repair
and support equipment, refer to Appendix D, Section II.
parts and special tools required for the performance of
organizational, direct support, general support, and
peculiar repair parts authorized for the performance of
depot maintenance of the early model M8A3 bulldozer.
maintenance at all levels for the early model M8A3
This repair part list and special tools must be used in
bulldozer. For listing of common repair parts, refer to
conjunction with Appendix D since only peculiar repair
parts for early model M8A3 bulldozers are identified. All
c. Special
Tools,
Test
and
Support
references in this section shall be construed to mean
Equipment Paragraph E-50. A list of peculiar special
early model M8A3 bulldozers, serial numbers 1 through
tools, test and support equipment authorized for the
59.
performance of maintenance at all levels for early
E-44. Peculiar Repair Parts Illustrations.
model M8A3 bulldozers. For listing of common special
a. The illustrations in this section identify
tools, test and support equipment, refer to Appendix D,
peculiar repair parts only. Refer to illustrations in
parts.
the following:
peculiar repair parts identification wherever common
Explanation of columns
configuration exists.
This eliminates duplicating
Special information
illustrations.
How to locate repair parts
E-45. Common Repair Parts Illustrations.
Both
Abbreviations and symbols
Federal Supply Codes for manufacturers
must be used together for complete early model M8A3
Recommendations
for
maintenance
repair parts coverage.
publication improvements
E-46. This peculiar Repair Parts and Special Tools
E-48. Prescribed Load Allowance (Peculiar to Early
List is divided into the following paragraphs.
Model Bulldozer)
a. Prescribed
Load
Allowance
(PLA)
special tools, test and support equipment having
quantitative allowances for initial stockage at the
AE-23
