Oil Filter Element.

ARMY TM 9-2805-259-14

AIR FORCE TO 38G2-89-54

NAVY NAVFAC P-8-615-14E

4-19. Oil Filter Element.

This task covers:

a. Replacement (Element Type)

b. Replacement (Spin on Type)

INITIAL SETUP

Tools

Materials/Parts

General Mechanic's Tool Kit (Item 1, Appendix B)

Oil, Engine (Item 3, Appendix D)

Wrench, Oil Filter (NSN 5120-00-865-0933)

Rags, Wiping (Item 7, Appendix D)

Solvent, Drycleaning (Item 8, Appendix D)

a. Replacement (Element Type). (figure 4-8)

(1) Remove screw (1) and gasket (2) and remove shell (3) and O-ring (4).

(2) Pour oil out of shell (3) into suitable container

(3) Remove element (5) from shell (3) and discard element (5).

WARNING

Drycleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and

property. Avoid repeated and prolonged skin contact. Do not use near open flame or

excessive heat. Flash point of solvent is 100F.138F. (38C.-60C.).

(4) Clean shell (3) and cover (6) with drycleaning solvent and dry thoroughly.

(5) Install element (5) in shell (3).

NOTE

Do not reuse O-ring or gasket. Install new O-ring and gasket upon installation.

(6) Install shell (3) and O-ring (4) and secure with screw (1) and gasket (2).

(7) Operate engine (para. 2-9) and check for leaks. Stop engine (para. 2-10) and check engine oil level and

replenish if low (refer to LO 9-2805-259-12 for proper grade oil).