TM 9-3405-206-14 & P
METAL CUTTING BAND SAW
BLADES
Those are regular set, hard-edge,
flexible-back standard blades for
cutting all metals.
For 14" Metal Cutting Band Saw: All
blades are 93 12 " long. 12 lb.
No. 28-703 30" Angle Blade Guides.
Consists of blade fingers, black-up
bearing and guide block.
For 20" metal cutting Band Saw: All
blades are 150" long. 2 lbs.
No.
28-708
Gravity
Feed
Attachment. Used primarily to avoid
operator fatigue. Provides a variable
feed pressure of approximately 5 to 20
pounds with standard 30-pound weight
provided. Enables operator to devote
No. 28-704 Circle Cutting
his entire attention to guiding the work,
Attachment. Attaches quickly to
assuring more accurate cutting. (For
guide arm, permitting radius cuts from
additional feed pressure, order extra
1 12 " to 15" in diameter.
weights.)
No. 25-857 Lamp Attachment, for
No. 28-826 Extra Weight. For 28-
115
V,
Includes
18"
flexible
825 Gravity Feed Attachment. With
gooseneck, reflector and 8-foot cord
one extra weight, attachment provides
with 2-prong plug. Uses standard bulb
approximately 10 to 41 pounds feed
(not included) up to 75 watts.
pressure, or with two extra weights, 15
No. 28-005 Blade Shear for mounting
to 50 pounds.
on welder face. Capacity to 1".
No. 28-709 Chip Blower, factory
mounted.
Consists of pump with
No. 28-705 Screw Feed Attachment .
pulley and 0 belt.
Consists of table mounting bracket,
No. 28-710 Chip Blower. Same as
screw with handle, and angle feed
28-709 except field mounted.
block.
No. 28-711 Safety Lock-Out Switch,
factory mounted. For machines with
magnetic controls only. Automatically
shuts off power when lower wheel door
is opened.
No. 41-707 Motor Pulley, 7 8 " bore,
No.
28-700 File Band Guide
Attachment. Easily bolts to guide
for 143T and 145T frame motors.
block. Includes mounting hardware.
No. 41-708 Motor Pulley, 1 18 " bore,
File bands not supplied by Rockwell.
for 182T and 184T frame motors.
No. 28-701 Blade Welder and Flash
No. 49-131 V-Belt, 43" O.C., 11M
No. 28-862 Fence Attachment for
Grinder, 115 V, 50/60 cycles, single
section.
ripping and re-sawing lumber.
phase,
3
KVA.
No. 49-132 V-Belt, 53 " O.C., 11M
Includes 2 " x 27" Micro-Set fence
Mounts flush into
section.
with front and rear locks, two 44"
band saw column.
tubular guide rails, mounting screws.
Capacity, 18 " to 1".
Fence may be set anywhere from 15
No. 49-159 Variable Speed Belt, 55"
' to left of blade to 25" to right with
O.C.
No. 28-702 Blade
Welder and Flash
zero to 25" to right.
Grinder. Same as
28-701 but for 230
V, Single phase.
5