TM 9-3405-206-14 & P
UNPACKING AND CLEANING
Carefully unpack the band saw, stand, and all loose items from the cartons. Remove the protective
coating from the machined surfaces of the band saw. This coating may be removed with a soft cloth
moistened pith kerosene (do not use acetone, gasoline or lacquer thinner for this purpose). After
cleaning, cover all unpainted surfaces with a good quality paste wax.
ASSEMBLING STAND, MOTOR PLATE, MOTOR, MOTOR PULLEY, AND SWITCH
If this band saw is received complete with stand and electricals factory
mounted and wired, as shown in Fig. 2, it is necessary to remove the
small knockout (A) located on top of the stand. The motor plate, motor,
motor pulley and switch are completely assembled to the stand as
Fig. 3
If this band saw is received with separate stand and electricals NOT factory
mounted and wired, the stand is supplied as shown in Fig. 4. Remove the
small knockout (A) Fig. 4, located on top of the stand and proceed as follows
to assemble the motor plate, motor, motor pulley and switch:
Fig. 4
8
