TM 9-3405-206-14 & P
1. Turn the stand upside down.
2. Assemble the motor mounting plate (A) Fig. 5, using the two hex
head capscrews flat washers and nuts (B). The other end of the
motor is fastened to the side of cabinet using a carriage bolt from the
outside of the cabinet and a flat washer and nut on the inside.
Fig. 5
3. Return the stand to the upright position and assemble band saw to stand using
four 1-1/2" roundhead slotted screws, flat washers, lockwashers and nuts, as
shown in Fig. 6.
Fig. 6
4. Assemble the motor to the motor mounting plate, as shown in
nuts.
Fig 7
9
