CHAPTER
2
OPERATION
F-FLOOD M-MIST N-NONE
TO USE THE JOB SELECTOR, FOLLOW THESE STEPS:
Turn the dial until the material to be cut is directly below the window in the cover
(1)
(see above).
Locate the recommended pitch and blade type listed next to the work thickness.
(2)
If a radius is being cut, locate the correct blade width on the radius chart. Having
(3)
determined the width, pitch and tooth type, refer to a saw blade specification table
to determine the gage and set.
Locate the recommended band speed for the work thickness and blade type used.
(4)
Note the recommended feed force to be used for the work thickness.
(5)
Note the recommended method of coolant application (if your machine is equipped
(6)
with drip or spray coolant applicators).
This completes the choice of blade and sets up requirements for the job. However,
(7)
these recommendations can be adjusted to meet particular requirements.
NOTE
Job selector recomnendations are for average straightline sawing
and manual contour sawing of work less than one inch thick.
5
