HOW TO ADJUST INSERT-TYPE SAW GUIDES
(1)
Select the set of inserts marked for the width of saw band being used,
(2)
Place the right-hand insert in the milled slot and tighten the screw lightly so that while
the insert will slide in the slot, it will still hold its position when released,
(3)
Select the proper insert gage for the gage of saw band being used.
(4)
Place the gage in the opposite slot and adjust the insert so that it meets the two gaging
edges. Then tighten the insert securely in place.
(5)
Place the left-hand insert in the slot and tighten the screw lightly.
(6)
Place the gage edgewise between the two inserts. Then bring the left-hand insert down
so that it rests against the gage. When the gage is removed, the gap left will be the
proper thickness for the saw band.
BAND INSTALLATION
(1)
Open the band wheel doors.
(2)
Unlock and open the bar which crosses the table saw slot, just below the front edge
of the table.
(3)
Remove saw band guard from post.
(4)
Using the gloves to handle the band, place it carefully over the wheels and
between the saw guide inserts.
(5)
Replace band guard, close and lock the bar over the table slot and close the
wheel doors.
6