WORK TABLE
The 30" X 30" heavy duty table has a removable center disk. Accessories can be bolted to
tapped mounting holes provided on the front and side edges of the table.
ADJUSTING TABLE TILT
Table tilt is used primarily when sawing compound angles. To tilt the table, use wrench provided
and loosen lock located below table. Tilt table manually until it is at desired angle. The amount
of table tilt (maximum -5 left, and 45 right) is shown by pointer and calibrated
scale mounted on trunnion.
Front sectional view of the work table and its mounting assembly.
USING BAND SPEED CONTROLS
The transmission gear shift control is used to select one of three transmission speed ratios low,
high, or medium. Band speeds within each range can be varied gradually by the speed change
control which changes the position of the variable pulley. Band speed is shown in feet per
minute (FPM) for each range on the speed indicator dial.
(1) Always allow the machine to come to a complete stop before shifting gears. If the
gears are not in a position to mesh,start and stop the machine intermittently until
they do. Do not attempt to force the shift control into place.
(2) Before stopping the machine, always turn the variable speed control to slow. An
interlock mechanism prevents shifting gears when the variable pulley is in its high
speed position.
10
