TM 9-3405-215-14&P
Clamp material and square work with blade by using
WORK LIGHT & MAGNIFIER
table tilting device. Connect power feed chain to mesh
with clamp gear teeth.
The operator can magnify cut area during delicate
sawing procedures. This is done with a magnifying lens
which fits over work light front portion. A protective lens
cover which prevents scratching should be placed
around magnifier when not in use. See Fig. 39.
FIG. 39. WORK LIGHT WITH MAGNIFYING LENS.
CHIP PAN
Your machine may be equipped with a removable chip
pan below lower wheel door. This pan catches chips
removed from lower wheel by chip brush. Remove pan
and clean out chips When necessary.
FIG. 37. HEAVY WORK CLAMPS.
HEAVY WORK SLIDES
Spark guard attaches to band guard with machine bolt.
Always use it when friction sawing. See Fig. 40.
Slide bars contain ball bearings, and a separate center
block to support material at sawing point.
Insert special center support block in table center disk.
Saw center block so a blade travel path or kerf is made.
This provides solid sawing point contact between work
FIG. 38. HEAVY WORK SLIDES.
FIG. 40. SPARK GUARD FASTENED TO UPPER SAW
GUIDE.
22