TM 9-3405-215-14&P
SECONDARY (AUXILIARY) TABLE
SLIDING TABLE (AIR FEED)
The secondary table measures 17 by 19 inches (430 by
A lever controlled air feed system allows this table
480 mm) and is used when straight through sawing of
forward or back movement under light hand pressure.
material sections longer than 35-112 inches (905 mm) is
Table locks permit loading and positioning heavy work
desired. This table does not tilt and can be used only
pieces. Maximum table travel is 12 in. (305 mm). Table
2
tilts 6 left, 45 right. Shop air at 80 psi (5.62 kg/cm ) is
when the two-wheel band guard has been removed. As
shown in Fig. 41, the table is mounted to a support unit
required.
which attaches to the machine frame behind the primary
table.
SUPPLY CABINET (Shipped Unassembled)
The supply cabinet provides orderly, safe storage for
saw band coils, welded saw bands, file bands, and
polishing bands. It is also useful for storing component
parts and removable machine accessories. See Fig. 42.
FIG. 41. SECONDARY TABLE.
DUST SPOUT
A dust spout may be provided on your machine just
below lower saw guide. A dust-collection tube can be
attached to this spout.
WELDER
Instructions covering the DBW-15 welder are provided
by a separate instruction manual included with machine
shipment.
BLADE SHEAR
Mounted on machine column, this tool is used to cut and
trim bands square preparatory to band butt welding.
FIG. 42. SUPPLY CABINET.
ETCHING PENCIL
Electric power for this tool is supplied by butt welder. If it
is used for marking on metal.
WORK TABLE OPTION
Your machine may be equipped with a factory-installed
30-inch (760 mm) square work table replacing the
standard 26-inch (660 mm) square table.
23