(4) Make a cut. One portion of the slit material will remain on the shear table, the other portion will bend down in
the throat of the machine.
(5) Advance a material keeping the cut edge remaining on the table, against the inside lip of the slitting gauge.
Make successive cuts.
Figure 39. Slitting Gauge
MAGNETIC SHEET SUPPORT
The Magnetic Sheet Support is normally furnished with a capacity of 16 ga. Mild steel with either a 36" or 48" Back
Gauge Range. (It can be furnished on special order for heavier capacity material.)
The proper adjustment of the magnetic channels is accomplished as follows:
(1)
Cut a strip of material, of the type will be sheared in production, about 2" to 3" wide and no longer than 35".
Figure 40. Magnetic Sheet Support
35
