TM 9-4110-254-14
5-36. COMPRESSOR B1 TESTING, REPAIR, AND REPLACEMENT. - Continued
e. Assembly.
(1)
Remove any gasket material from all machined gasket surfaces.
(2)
Install new bottom plate gasket (54), bottom plate (53), and 17 screws (52).
(3)
Install mounting foot plate (51), two new lock washers (50), and screws (49).
(4)
Install new oil pump gasket (48), oil pump (47), and six screws (46).
(5)
Install new seal (45), sight glass (1) and three screws (44).
(6)
Install protector (43) and two screws (42).
(7)
Install new terminal mounting plate gasket (41), terminal plate (40), and 10 screws (39).
(8)
Install new fused cluster seal (38), new fused cluster terminal (37), and three screws (36).
(9)
Install terminal box (35) and four screws (34).
(10) Install new valve plate gasket (11), four reed valves (10), valve plate assembly (9), new cylinder head
gasket (8), cylinder head (7), and rune screws (6).
(11) Check compressor lubricating oil level at sight glass (1). Level should be at mid-point of sight glass.
Add or remove oil as necessary.
(a) Remove plug (2)
(b) Add or remove oil as necessary
(c) Wrap anti-seize tape around plug (2) threads
(d) Install plug (2).
f.
Installation
(1)
Install two service valves (23) onto tubing (24) with mounting surfaces at right angles to each other and
(2)
Install four new lock washers (33), screws (32), and nuts (31).
(3) Install four mounting springs (29) and shipping brackets (30).
WARNING
Compressor weight exceeds 240 lb (109 kg) Use appropriate lifting
device to avoid personal injury.
(4)
Install compressor (5), four mounting spacers (28), and new locknuts (27).
(5)
Install suction screen (26), two new service valve gaskets (25), service valves (23), and four screws (22)
5-80