TM 9-4110-255-14
4-61. ENGINE REPAIR AND REPLACEMENT. - Continued
b. Installation.
(1)
Prepare New Engine.
Certain components shipped with new engine must be removed prior to
installation.
NOTE
Hoses may contain fuel. Appropriate actions should be taken to contain spills.
(a)
Remove and discard protective cap (18) from fuel pump (19).
(b)
Remove union (20), washer (21), eye (22), and washer (23) from fuel pump (19).
(c)
Remove union (24), washer (25), eye (26), and washer (27) from fuel filter assembly (28).
(d)
Place drain pan under fuel filter assembly (28). Remove nut (29), b lt (30), and spacer (31). Invert
o
fuel filter assembly to drain fuel into drain pan. Retain fuel filter assembly for use as spare part.
(e)
Contact your local environmental officer for guidance on how to properly dispose of used fuel in
accordance with local regulations.
(f)
Remove two nuts (32), lock washers (33), and gasket (34). Retain gasket for use during installation.
(g)
Cut wire lead (35) just above cap (36).
(h)
Remove two screws (37) and voltage regulator (38). Retain voltage regulatorfor use as spare part.
(i)
Remove two screws (39) and gasket (40). Retain gasket for use during installation.
(j)
Install engine guard (17), two flat washers (16), and new rivets (15).
(k)
Drill a 0.15 in. (0.38 cm) hole in engine stop lever (41) at existing hole location (42).
WARNING
Engine weight exceeds 95 lb. (43 kg). Use appropriate lifting device to avoid personal injury.
(2)
Using an appropriate lifting device, carefully install engine (14).
(3)
Install adjustment channel bracket (12) onto swivel bolt (13). Turn in swivel bolt and secure adjustment
channel bracket with two new lock washers (11) and bolts (10).
4-142
