TM 9-4110-255-14
4-62. FUEL SUPPLY HOSES/FUEL PIPE REPAIR AND REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Materials/Parts:
Materials/Parts:
Tie Down Straps (As Required)
Gasket
5, Appendix E
17, Appendix G
Wiping Rags
Nut
9, Appendix E
24, Appendix G
Washers (4)
Ferrule Tube
14, Appendix G
25, Appendix G
Washers (4)
Connector
16, Appendix G
26, Appendix G
Washer
18, Appendix G
Equipment Conditions:
Washer
Refrigeration unit shut down (para 2-7) and battery
19, Appendix G
disconnected (para 4-35).
Washers (2)
Both side doors open.
20, Appendix G
Washers (2)
21, Appendix G
NOTE
Hose repair is limited to replacement of damaged components or assemblies.
a. Removal.
WARNING
Hoses and fuel pipe may contain fuel. Injury to personnel can occur when removing.
Appropriate actions should be taken to contain spills.
(1)
Fuel tank to in-line fuel filter hose assembly.
(a) Cut tie down straps (1) and remove loom (2).
(b) Note in-line filter (3) flow direction then loosen two clamps (4) and remove hose (5).
NOTE
Connector, nut, and tube ferrule are not re-usable. Do not remove unless any of these parts or
fuel inlet elbow must be replaced.
(c)
If connector (6) or fuel inlet elbow (7) is damaged, loosen nut (8) then remove connector, tube
ferrule (9), and if damaged, inlet elbow. Discard connector, nut, and tube ferrule.
4-144
