TM 9-4110-255-14
5-48. ALTERNATOR REPLACEMENT .-Continued
b. Installation.
(1) Install alternator coil (9) and secure with four screws (8).
(2) Route alternator coil (9) leads as necessary and install two safety plates (5), flat washers (4), and screws
(3).
(3) Using tags and wiring diagram (fig. 1-4), connect wire leads (6 (para 4-20). Remove tags.
)
(4) Install alternator magnet (2) and secure with five screws (1).
NOTE
FOLLOW-ON MAINTENANCE:
Install flywheel (para 5-47).
5-49. ENGINE AND COMPRESSOR BASE REPLACEMENT .
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Materials/Parts:
Equipment Conditions:
Lock Washers (2)
Engine removed (para 4-61).
12, Appendix G
Compressor removed (para 5-40).
Self Locking Nuts (4)
10, Appendix G
Lock Washers (8)
12, Appendix G
a. Removal.
(1) Remove swivel bolt (1).
(2) Remove four self locking nuts (2), flat washers (3), and two engine mount spacer plates (4). Discard self
locking nuts.
(4) Remove engine mount (5).
(5) Remove eight nuts (6), lock washers (7), and four isolator mounts (8). Discard lock washers.
(6) Remove engine and compressor base (9).
5-100
