TM9-4120-370-14
TO35E9-229-1
4-45. JUNCTION BOX REMOVAL/INSTALLATION - Continued.
Tilt top of lower front panel out and lift panel up to remove.
(4)
Disconnect P1O, P4, P14, P13, and P21 harness connectors.
(5)
Using screwdriver and wrench, remove two screws, lock washers, and nuts from circuit breaker push-pull
(6)
control wire clamp.
Remove clamp and spacer plate.
(7)
Loosen screw in core end fitting and remove core end fitting.
(8)
Pull pushpull control wire end free of actuator arm.
(9)
Figure 4-60. Junction
Box Harness and Lead Disconnect
