TM9-4120-370-14
TO35E9-229-1
4-42. BLOCK-OFF ASSEMBLY - Continued.
Removal
a.
(1) Remove lower front panel. (See para 4-25.)
(2) If the P8 connector is installed, use a screwdriver and wrench to remove four screws and nuts from P8
connector.
(3) Pull connector from block-off panel.
(4) If alternate location for power connector was used, remove it also.
(5) Using two wrenches, remove four bolts and nuts from upper flanges.
(6) Remove block-off panel.
b.
Inspection
(1) Check block-off for missing parts, loose hardware, and cracks or dents that would create a hazard or inter-
fere with operation.
NOTE
If the alternate power and control connector locations in the conditioned air intake are
used, both cover plates should be installed on block-off.
(2) Replace all missing or damaged parts.
Repair. Repairs are limited to replacement of missing or damaged parts.
c.
d. Installation. (See installation instructions paragraph 4-7.)
(1) If applicable, use screwdriver and wrench to secure P8 connector and harness with four screws and nuts.
(2) If applicable install power connector in like manner,
(3) Using two wrenches, secure block-off to air conditioner with four bolts and nuts.
