TM 9-4120-388-14
4-38. WIRING HARNESS, CONTROL PANEL - Continued.
Removal.
c.
(1) Remove four screws and nuts from (J7) connector.
(2) Remove lock nut, Iockwasher, and flat washer from ground stud.
(3) Tag and disconnect leads from switches.
(4) Remove harness.
d. Repair.
(2) See Table 4-3 (Wire List) for wire lengths and terminal information when individual wires are replaced.
Installation.
e.
(1)
(2)
Secure ground wire to ground stud with flat washer, Iockwasher, and lock nut.
Remove tags.
(3)
(4)
Secure connector (J7) to box with four screws and nuts.
Insert rear panel into box and align holes.
(5)
(6)
Secure rear panel with four screws and lock nuts.
(7)
Place TEMPerature control thermostat knob on shaft and align setscrew with flat on shaft.
Tighten setscrews.
(8)
(9)