TM 9-4120-388-14
b. Inspection
a. Access
This task consists of:
d. Removal
C. Test
e. Installation
INITIAL SET-UP:
Remove control panel (4-37).
Access.
a.
(1) Loosen Temperature control thermostat knob setscrew.
(2) Remove knob.
(3) Remove four screws and lock nuts that secure rear panel.
(4) Pull rear panel away from box as far as harness will allow.
b. Inspection.
(1) Be sure that leads are properly connected. (See wiring diagram, Figure 4-16.)
(2) Be sure that capillary line and sensing bulb are not damaged.
(3) Check TEMPerature control thermostat for signs of overheating or other obvious damage. Replace if damaged.
4-76
